can steroids mixed be warmed before injecting.

hi
could someone advise if i mix tren 150, super test 320, and masteron, all 1ml, in one syringe, so then i have to inject 3ml of this mix,all by pgw be warmed with a hot towel or bean bag so that the oil is more "thin" so that the injection is less painfull and the site is not so painful in the days to follow..i have tried the warm version and the there is not much discomfort or pain, the pain is gone in about 3 days but not warmed the pain is for about more than a week.

Yes, you can use a hot towel/bean bag or you can put the syringe in hot water. Make sure the water is not to hot (boiling) as you don't want to denature the chemical composition of the test. I wouldn't put it in water above 60 degrees celcius and what ever you do don't use the microwave.

I use the fat heater i have... put it in front of that for like 10 seconds...

I always run warm tap water over the syringe with the gear in (cap on needle to keep it sterile). It definitely makes a difference to pain after the shots. Homebrewed gear is heated to much higher temperatures than this without affecting the potency so its not a problem.

I just keep my shit at room temp and then inject it like that and i don't get any saw , pain full injections(room temp is around 22*c)

Was planning to warm it with hair dryer - assume that would be ok to?

Should be fine, just don't leave it blowing to long - those things get flippen hot.

I use the hair dryer, its quick and effective. I hold it for like 3/4seconds max. Other wise as Stuart says it gets really really hot.